TL;DR
- A COA (Certificate of Analysis) is the result of testing for “that specific product, from that specific batch.” First, verify that the product name, batch number, and test date match the packaging.
- In Japan, starting December 12, 2024, there are residual limits for Δ9-THC in products. Fats and oils (liquid at room temperature) and powders have a limit of 10 ppm, aqueous solutions 0.10 ppm, and all others 1 ppm (Ministry of Health, Labour and Welfare).
- The amount of Δ9-THC is calculated as the total of “Δ9-THC + Δ9-THCA-A × 0.877” (example of analytical method by the MHLW).
- “ND” (Not Detected) does not mean “zero,” but rather “below the limit of detection (LOD).” Check whether the LOD and LOQ (limit of quantification) are sufficiently lower than the limit. The MHLW recommends being able to quantify down to one order of magnitude below the limit.
- This page provides general information. It does not determine whether individual products comply with laws and regulations.
1. Checklist (Check from top to bottom)
| # | Item to Check | What to Look At | Notes |
|---|---|---|---|
| 1 | Match between product and batch | Product name, batch number (Lot / Batch No.), net quantity | A COA that does not match the batch number on the packaging is not proof for that product |
| 2 | Testing laboratory | Laboratory name, address, contact info, signatory | Is it a third-party lab rather than the seller themselves? The MHLW publishes a list of “testing laboratories declared capable of measuring Δ9-THC content” (see sources below) |
| 3 | Dates | Sample receipt date, test date, issue date | Are the chronological relationships with the manufacturing/import dates logical? |
| 4 | Sample category | Fats & oils/powders / aqueous solutions / others | Residual limits differ depending on the category (Section 2) |
| 5 | Δ9-THC and Δ9-THCA-A | Values for both (or combined value) | Because Δ9-THCA-A easily turns into Δ9-THC upon decarboxylation, evaluate them combined (Section 3) |
| 6 | Units | ppm, mg/kg, %, mg/g | Mixing up units changes the decimal place (conversion table in Section 2) |
| 7 | LOD and LOQ | Values serving as the basis for “ND” and “<LOQ” | If the LOD/LOQ is higher than the limit, even an “ND” result cannot prove it is below the limit |
| 8 | Analytical method | LC-MS/MS, LC-QTOF MS, HPLC, GC-MS, etc. | MHLW examples are LC-MS/MS or LC-QTOF MS. Using analytical methods other than these examples is not prohibited |
| 9 | Other components | CBD content, presence of designated substances, etc. | Do the labeled amounts and COA values match closely? CBN will be a designated substance starting June 1, 2026 |
| 10 | Authenticity | Method of inquiry to issuer, QR codes, etc. | If tampering is suspected, contact the testing lab that issued the COA directly |
2. Residual Limits and Unit Conversion
Residual limits for Δ9-THC in products indicated by the MHLW (enforced December 12, 2024):
| Category (MHLW terminology) | Residual Limit | mg/kg | % |
|---|---|---|---|
| Fats and oils (limited to those liquid at room temperature) and powders | 10 ppm | 10 mg/kg | 0.0010% |
| Aqueous solutions | 0.10 ppm | 0.10 mg/kg | 0.000010% |
| Other than the above | 1 ppm | 1 mg/kg | 0.0001% |
Unit conversion (all by weight):
| Unit | Converted to ppm |
|---|---|
| 1 mg/kg | 1 ppm |
| 1 mg/g | 1,000 ppm |
| 1 % | 10,000 ppm |
| 0.001 % | 10 ppm |
3. How to Calculate Total Δ9-THC
In the MHLW’s analytical method examples (notification dated November 12, 2024), the amount of Δ9-THC to compare against the residual limit is calculated using the following formula:
Total Δ9-THC (mg/kg) = Δ9-THC (mg/kg) + 0.877 × Δ9-THCA-A (mg/kg)
Calculation example (figures are fictitious): If Δ9-THC is 0.20 mg/kg and Δ9-THCA-A is 0.30 mg/kg → 0.20 + 0.877 × 0.30 = 0.4631 mg/kg (approx. 0.46 ppm)
- Overseas COAs showing “Total THC” may use different calculation formulas or standards (such as dry weight basis) compared to Japan. Always verify the original figures and units.
- An “ND” row means “below LOD.” A COA without the LOD value makes it impossible to determine how low of a level is being demonstrated.
4. Common Oversights
- COA for a different batch: Even with the same product name, a different batch means different test results.
- COA for raw materials only: A COA for a raw material (like isolate) does not show the results for the final product (like oil or gummies).
- LOQ is too high: For example, the limit for aqueous solutions is 0.10 ppm. Even with a test result of “<LOQ” at an LOQ of 1 ppm, it cannot prove the level is 0.10 ppm or lower.
- Results near the limit: The MHLW states that if Δ9-THC near the limit is detected, the validity of the analytical method must be verified for each product.
- Presence of accreditation: Laboratory accreditation such as ISO/IEC 17025 is one measure of quality control (also check the scope of accreditation—which items and analytical methods are covered). Confirm whether it is a regulatory requirement via authority documents.
5. Sources (Official Documents)
- MHLW, “Partial enforcement of the ‘Act for Partial Revision of the Cannabis Control Act and the Narcotics and Psychotropics Control Act’ on March 1, 2025” (Residual limits and testing lab list): 令和7年3月1日に「大麻取締法及び麻薬及び向精神薬取締法の一部を改正する法律」の一部が施行されます|厚生労働省
- MHLW, “Regarding examples of analytical methods pertaining to residual limits of Δ9-THC contained in cannabis-derived products, etc.” (Yakukanma Notification No. 1112 #3, November 12, 2024): https://www.mhlw.go.jp/content/11120000/001330798.pdf
- MHLW, “Institutions capable of testing for Δ9-THC content in products” (As of August 6, 2026): https://www.mhlw.go.jp/content/11120000/001734312.pdf
- MHLW, Kanto-Shinetsu Regional Bureau of Health and Welfare, Narcotics Control Department, “Regarding the import of CBD-related products such as CBD oil”: CBDオイル等のCBD関連製品の輸入について | 麻薬取締部ウェブサイト
- MHLW, “Regarding the designation of CBN as a designated substance”: CBNの指定薬物の指定について|厚生労働省
Knowledge Base (Wiki) Series
- How to read a COA (Certificate of Analysis) (This page)
- Timeline of Japanese cannabis and CBD regulations
- Japanese-English Glossary
- Gateway to official documents and research papers
- Testing laboratories, exhibitions, and industry associations
- This page is a Wiki. Contributors with reliability level 2 (members) or higher can edit it. When editing, please provide sources (URLs of official institutions, research papers, etc.) and leave a reason for your edit (version history is public).
- Do not write efficacy or medicinal claims (such as “cures X” or “effective for Y”). Product promotion and sales solicitation are also prohibited.
- This page provides general information and does not constitute legal judgment or medical advice. For individual decisions, please consult authorities such as the Regional Bureau of Health and Welfare’s Narcotics Control Department, or specialists such as lawyers and pharmacists.
Last updated: 2026-10-04 / Supervised by: CBD Department Editorial Team